POWDP15210
EN
Copyright © 2020 VARO
P a g e
|
10
www.varo.com
9.6
Adjusting the torque
The torque is adjusted by rotating the torque setting ring; the torque is greater when the torque
setting is set on a higher position. The torque is less when the torque setting ring is set on a
low position
“
1
”
denote
lowest and “23” denote highest.
Torque is set by means of a torque setting according to different screw and different material,
you can adjust suitable torque, if the screw is long and material is hard, you can adjust the
bigger setting.
Remark:
The torque setting function works only in combination with the screw driver mode.
9.7
Function mode selector
▪
Turn the function mode selector and let the pointer align to the impact mode
that
selects the impact mode of action.
▪
Turn the function mode selector and let the pointer align to the drill mode
that selects
the drill mode of action.
▪
Turn the function mode selector and let the pointer align to the screwdriver mode
that
selects the screwdriver mode of action.
9.8
Speed selector (Fig 6)
NOTE
：
Mark
“
1
”
is Low speed position, mark
“
2
”
is High speed
position that moulding onto the button of two speed selector.
The drill has a two-speed gear train designed for drilling at 1 (LOW) or 2 (HIGH) speed. A gear
selector is located on top of the drill to select either low or high speed. When you push the
button forward and select low speed range, the speed will decrease but will provide more
power and torque. When using drill in the high speed range. Speed will increase but will
provide less power and torque. Use low speed for high power and torque application and high
speed for fast drilling applications.
Important: NEVER adjust this two speed selector whilst the drill is running.
Always let it come to a complete stop first.
9.9
LED light (Fig 7)
The LED work-light can light prior to motor running if you press the switch lightly, which keep
the work area to be lighted for checking clearly at first, and it lights also during your operation.
WARNING: Do not stare directly at the light beam. Never aim the beam at
any person or an object other than the work piece.
Do not deliberately aim the beam at personnel and ensure that it is not
directed towards the eye of a person for longer than 0.25s.
10 DRILLING
10.1
Drilling
Before use for drilling, the function mode selector should be set on drill position
“
”.
