POWX07590
EN
Copyright © 2019 VARO
P a g e
|
7
www.varo.com
▪
Use extra caution when cutting a workpiece that is twisted, knotted, warped or does not
have a straight edge to guide it with a mitre gauge or along the fence.
▪
Never cut more than one workpiece, stacked vertically or horizontally.
▪
When restarting the saw with the saw blade in the workpiece, centre the saw blade in the
kerf so that the saw teeth are not engaged in the material.
.
▪
Keep saw blades clean, sharp, and with sufficient set. Never use warped saw blades or
saw blades with cracked or broken teeth.
6.4
Table saw operating procedure warnings
▪
Turn off the table saw and disconnect the power cord when removing the table insert,
changing the saw blade or making adjustments to the riving knife or saw blade guard, and
when the machine is left unattended.
▪
Never leave the table saw running unattended. Turn it off and don’t leave the tool until it
comes to a complete stop.
▪
Locate the table saw in a well-lit and level area where you can maintain good footing and
balance. It should be installed in an area that provides enough room to easily handle the
size of your workpiece.
▪
Frequently clean and remove sawdust from under the saw table and/or the dust collection
device.
▪
The table saw must be secured
.
▪
Remove tools, wood scraps, etc. from the table before the table saw is turned on.
▪
Always use saw blades with correct size and shape (diamond versus round) of arbour
holes.
▪
Never use damaged or incorrect saw blade mounting means such as flanges, saw blade
washers, bolts or nuts.
▪
Never stand on the table saw, do not use it as a stepping stool.
▪
Make sure that the saw blade is installed to rotate in the proper direction. Do not use
grinding wheels, wire brushes, or abrasive wheels on a table saw.
7 SAFETY EQUIPMENT
7.1
Cleaving wedge
The cleaving wedge (8) prevents a workpiece being caught by the ascending teeth and being
thrown against the operator. The cleaving wedge must remain in place during operation.
7.2
Saw blade protector
The saw blade guard (7) protects the user from accidentally touching the saw blade and from
flying splinters. The saw blade protector must always remain in place during operation.
7.3
Push stick
The push stick (13)) serves as an extension of the hand and protects the user from
accidentally touching the saw blade. The push stick must always be used when the gap
between the stop and the saw blade is less than 120 mm.
8 UNPACKING AND ASSEMBLY
Unpack the unit and make sure all of the pieces are there.
Lower the saw blade underneath the table surface (see 8.4 Setting cutting height)
Turn the saw table up-side down
Note: If any of the parts is missing or damaged contact the retailer.
8.1
Assembly (Fig. 1)
First attach L and R table extensions to the table saw (without the brackets)
Mount the base frame and attach it to the table saw
