POWX0496
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
7 OPERATION
Switching on and off (fig. A)
To switch the tool
on, set the on/off switch (1) to ‘I’.
To switch the tool
off, set the on/off switch (1) to ‘0’.
When using wax and polishes, please observe the manufacturers'
instructions
Pull the textile polishing cap over the polishing pad. Make
sure the polishing cap is completely clean.
Spread the polish evenly over the polishing pad. Do not
apply the polish directly to the car bodywork
Switch the tool on and off only when it is resting on the
car bodywork.
Place the mains cable over your shoulder and work first
on large, flat surfaces such as the bonnet, boot lid and
roof. Keep your movements as regular as possible.
Important! Allow the polishing tool to glide over the
polishing surface. Do not apply pressure !
Next work on the smaller surfaces (doors, for example).
Allow the mains cable to hang from the appliance and
hold the tool as illustrated.
For the areas that cannot be easily reached (for example,
rear view mirrors, bumpers and door handles) remove the
polishing cover and polish these areas by hand.
