Step 3:
•
On the bottom
supply roll, grasp
the laminated starter
section by the leading
edge film.
•
Route over the bottom
idler bar adjacent to
the lower rubber roller.
•
Make sure the film
is inserted squarely.
Rotate the handle 1/4
turn in the direction of
the arrows.
Step 4:
•
Make certain the
lower film is tight.
If necessary, rotate
the supply roll in the
direction of the arrows
until the film is taut.
•
Grasp the film from
the upper supply roll
and adhere it to the
film on the lower
supply roll.
By carefully aligning the
edges, keeping the
film tight and avoiding
wrinkles, film waste will be
minimized.
Step 5:
•
Rotate the handle to
pull the supplies
through the machine.
•
Ensure that the film
exits between the
blade bars.
•
Just before the top film
becomes tight again,
insert a small piece of
cardstock between the
rubber rollers. This will
help to minimize waste
and ensure the film
exits between the
upper cut bar and
lower guide.
Step 6:
•
Continue to crank film through
machine until it is aligned and
wrinkle-free.
•
Trim off excess film by pressing down
on the blade holder and sliding in
either direction.
Step 7:
•
Replace the top cover.
•
Close the lower access door.
•
Install feed tray completely by aligning
the support posts in the grooves
located in the sides of the machine.
When done correctly, the film layers should be aligned and wrinkle-free after 18"
(45cm) of material has exited the machine.
