Variquest Motiva 400, Руководство пользователя

Страница: 13 / 26

2-4
VariQuest
®
Motiva™ 400 User’s Guide
Adjusting Label Stock Gap Sensor Position
Circular Labels
Circular Labels
When using Circular Labels, you must adjust the Stock Gap sensor to correspond
with the very top of the label where the circles are closest together. If the sensor is
too far to the right or left, the printer will still sense the label but the image may be
offset downward because the printer will start printing at the wrong position. If you
are using stock that has multiple labels across, make sure the sensor corresponds
to a place on the stock that has a label and not a vertical gap.
The Sensor Bar has a guide in inches and millimeters to help identify where to set
the bar to align the sensor over any identifying mark or top of a circular shape. To
do this:
1. Measure the distance from the edge of the label stock to the correct position
on the stock.
2. Set the sensor bar to this measurement (e.g., For a two inch circular die-cut
label, measure from the edge of the label stock to the center of the circle. For
this example it should be about 1 1/8 inches.)
3. Set the Sensor Bar to the measured value.
Center of Circle
Center of Hole
Circular Labels
Through-Hole Labels