Varioprop Uno S2R, Инструкция по эксплуатации

Страница: 8 / 10

Check the receiver, servos, and battery connectors, to be sure they are firmly connected. If a connector is not fully
inserted, vibration may cause the connector to work loose while the model is operating. This will result in loss of
control.
Operate each servo horn over its full stroke and check to see that the linkage does not bind or is not too loose.
Excessive force applied to the servo horn by binding or poor installation may lead to servo problems and result in loss
of control.
Electric Cars and Boats : Isolate the receiver from vibration by attaching to the chassis or mounting plate with thick
double sided tape.
Gas Powered Cars and Boats : Isolate the receiver from vibration by wrapping it in foam rubber or similar type cush-
ioning material. Protect the unit from water damage by placing it in a plastic bag or waterproof radio box.
The receiver contains precision electronic parts. These parts are vulnerable to vibration and shock. Any contact with
moisture (water or condensation) may cause receiver malfunction and loss of control.
Keep all devices that emit high frequency noise, such as motors, batteries, and wiring that handles heavy current
loads, at least 1/2 inch away from the receiver and the receiver antenna. High frequency noise will cause a decrease
in operating range and could cause loss of control.
Install electronic speed control heat sinks as well as other components that conduct electricity so they can not come
in contact with aluminium, carbon fibre or other materials that conduct electricity.
If, for example, the speed control came loose while the model was running and touched an aluminium chassis, a
short circuit may occur that would cause irreparable damage to the system as well as loss of control.
Noise suppression capacitors should be installed on almost all motors. If the proper capacitors are not installed, high
frequency noise will reduce range and cause loss of control along with various other problems.
Inspect all linkage installations and any point where metal could come in contact with other metal parts. Make sure
these parts do not touch other metal parts under vibration. Should a linkage or other metal parts come in contact
with other metal parts under vibration, the high frequency noise generated by this contact will cause interference and
possible loss of control.
Do Not disassemble any part of this system that is not specified in the instruction manual. Varioprop will not be
responsible for any damage due to improper disassembly of any part of the radio control system.
The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer.
8
PRECAUTIONS
CAUTION