Varioprop Uno S2R, Инструкция по эксплуатации

Страница: 6 / 10

Receiver
Button
Antenna
Receiver Button
LINK/BIND Button
Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver must be linked with
the ID code of the transmitter with which it is being paired. Once the link is made, the ID code is stored in the receiver and
no further linking is necessary unless the receiver needs to be used with another Varioprop S2R transmitter.
LINKING/BINDING PROCEDURE:
1. Turn On the Transmitter with pressing on the receiver button for 5 seconds
2. The red LED is flashing slow
3. Power On the receiver
4. The red receiver LED is flashing slow
5. Press the receiver button
6. The linking is finished once the receiver LED stop flashing
Please note! The transmitter stops the linking procedure after the third double beep signal.
The S2R comes with failsafe set to neutral position on steering and throttle channel. In the event of loss of signal the motor
will stop and the vehicle will drift. If the signal is regained normal function will return.
If you wish to program the failsafe to a custom setting just follow these simple steps:
1. With both the transmitter and receiver powered ON, press the receiver button on the receiver for about 3 seconds.
2. The receiver will enter the failsafe setting menu and the receiver LED will flash.
3. You have about 3 seconds to move the transmitter controls (steering and throttle at the same time) to the position that
you wish to program into failsafe.
4. After the 3 seconds the receiver will save the settings and return to normal mode.
5. If you wish to reset to a different setting, simply repeat the above steps.
Please note!
We recommend to let the failsafe in the neutral position for use in electric powered cars and boats.
6
LINKING THE RECEIVER AND TRANSMITTER
FAILSAFE SETTING