Varimixer Flexlift, Инструкция по эксплуатации и запасные части

Страница: 8 / 55

Page 8
9. Lifting equipment
9.1. Turning Unit
Application
The turning unit to move the load in a sideways rotational movement.
Operation
To engage the electrical turning the buttons 3 and 4 of the remote control are used.
See paragraph on operation to identify the correct buttons.
Safety when using the Turning unit
Before the turning unit is activated test that the load is correctly held between the
arms of the tool. This is done by ensuring that all contact areas of the tool indeed
has contact to the load. Make sure that the load is lifted high enough that no
collision with legs or floor and load can occur.
Adjustment of the Turning unit
Adjustment of the PLC parametres should only be done by professionals.
See paragraph ‘Adjusting speed and Amps for electric equipment’
9.2. The gripping device - Flexlift
Application
The gripping device is used to handle items
Operation
Buttons 5, 6, 7 and 8 are used to operate the electrical griping function.
Buttons 5 and 6 activate the closing function; buttons 7 and 8 activate the opening function.
Safety when using the gripping device
Due to the risk of dropping the load through improper operation of the remote control, the opening and
closing functions are operated with two buttons; i.e. both buttons must be activated in order to perform the
desired movement.
Caution:
there is a risk of clamping if the safety instructions for using the lifter are not observed.