VARILITE VL5LED WASH, Руководство пользователя

Страница: 6 / 31

USER MANUAL
WWW.VA R I - L I T E .CO M
VL5LED WASH
6
To connect power and data:
Step 1. Connect data cable from console to fi rst luminaire in chain at DATA IN connector.
Step 2. If required, connect additional data cables from DATA THRU connectors to DATA IN connectors of
remaining luminaires in link.
Step 3. At last luminaire in link, install male termination connector at DATA THRU connector. (Luminaires and
other devices on the same DMX chain may not function properly without termination.)
Step 4. Connect AC Input Cable connector to power input source.
Step 5. Dress AC input and data cables and secure them so that they will not interfere with luminaire head
and yoke movement.
POWERING UP
POWER UP AND CONFIGURATION PROCEDURE
The internal color, gobo, and beam mechanisms will also move through a full range of motion. After calibration,
the luminaire head will either stop at its “home” position (which positions the pan axis at mid-rotation and the
head parallel to the yoke with the lens pointing away from the luminaire upper enclosure) or move to its current
DMX-defi ned position if DMX data is present. All internal mechanisms also move to their “home” or DMX-de-
fi ned positions.
Subsequently, depending on the luminaire’s setting for Power-Up State (refer to “VL5LED WASH Menu System
Function Chart” on page 45).
CAUTION
: Before applying power, be sure the luminaire is hung or positioned so that the head and yoke can
move freely without restriction. Make sure service tilt and pan locks are disengaged so luminaire moves freely.
To power up:
Step 1. At each luminaire, apply power by connecting luminaire to input power source (100 to 240VAC). Lu-
minaire will cycle through calibration and stop at “home” position.
ADDRESSING
PROGRAM STARTING ADDRESS
The address setting for DMX console controlled systems is entered using the Menu Display. The luminaire retains
the DMX address even if power is removed.
NOTE
: Refer to your console operating instructions for specifi c information regarding its addressing require-
ments.
To program a DMX starting address:
Step 1. Power unit on (either via mains or battery)
Step 2. Press [ESC] to access menu
Step 3. Press [
▲
] or [
▼
] to access ADDRESS and press [OK].
Step 4. Use [
◄
] or [
►
] to move cursor to Hundreds, Tens or Ones...then press [
◄
] or [
►
] to select desired
digit. Note it will scroll from 9 to 0 or 0 to 9. Once all three digits are set, press [OK] to accept.
DMX 512
(from console
or control device)
DMX 512
(out from first to
second luminaire)
DMX 512
(out to the next
luminaire or DMX512
controlled device)