Page 17
© 2013 Cascade Designs, Inc.
Installation Instructions
Troubleshooting
The Icon Back System should operate smoothly. The back support should
remove and insert without binding. If the back support binds or seems
“sticky” during removal and insertion, quick and easy adjustments will
correct the situation.
1. Check the back height. Ensure that the Cane Brackets are installed at the same
height and are parallel.
2. Allow the Slide Brackets to self-center. Loosen the left and right Slide Bracket
screws until the Slide Brackets fit loosely and self-center in the Holsters. Tighten
the Slide Bracket Screws.
3. Check the depth adjustment.
Ensure that the depth
adjustment is the same on the
left and right Holsters. Loosen
the top and bottom Cane
Bracket Adjustment Screws a
three-quarter (3/4) turn. While
holding the back system at the
appropriate depth, tighten the
top and bottom adjustment
screws.
4. Check the angle adjustment.
Ensure that the angle
adjustment is the same on the left and right Holsters. Loosen the top Cane
Bracket Adjustment Screws a three-quarter (¾) turn. While holding the back
support at the appropriate angle, tighten the top adjustment screw.
Only loosen the Cane Bracket Screw three-quarter (¾) turn when making
angle or depth adjustments.
Loosening the screw more than a three-quarter (¾) turn will cause it to
disconnect from the nut inside the Holster.
1. ADJUST
WIDTH
2. ADJUST
ANGLE
