Vari CB-80, Перевод оригинальной инструкции

Страница: 33 / 60

CB-80 CB-80B CB-80Z CB-80ZI
2.6.8 Servicing intervals
Activity Before use During the season Before storing
Check the engine oil level yes according to the engine operating
manual yes
Clean the engine air filter check every 10 hrs 70 yes
Washing - as needed yes
Check the tightness of screw
connections
yes every 5 hrs yes
Lubrication inspect condition Table 10 yes
Check V-belts - every 20 hrs yes
Table 16: Service intervals
2.6.8.1 Problems and troubleshooting
Problem Cause Solution
Engine won’t start No gasoline in the tank Fill the tank with gasoline
Fuel supply is closed Open the fuel supply
Other defect Contact the service centre
The work tool does not turn Engine is not started Start the engine
The drive clutch lever is not depressed Depress the lever
The belt is loose Adjust the tensioner
Broken belt Replace the belt with a new one
Belt slid off Seat the belt
Other defect Contact the service centre
Machine does not mowe Engine is not started Start the engine
The drive clutch lever is not depressed Depress the lever
The belt is loose Adjust both tensioners
Broken belt Replace the belt with a new one
Belt slid off Seat the belt
Fallen out bolt of the gearbox upper pulley carrier Fit a new pulley bolt
Other defect Contact the service centre
Machine or move of work tool cannot be
stopped The tensioner does not return Lubricate
The wire in the Bowden cable is stiff, Bowden cable bent Lubricate or replace Bowden cable, as necessary
Control levers do not return The wire in the Bowden cable is stiff, Bowden cable bent Lubricate or replace Bowden cable, as necessary
Broken return spring Replace with new spring
Other defect Contact the service centre
Other defect Contact the service centre
Table 17: Problems and troubleshooting
2.6.8.2 Storage

During a shutdown, even a short one, always provide a rest for the support wheel by means of a suitable block approx.
4 cm high to prevent deformation of the bristles of the cylinder sweeping brushes.
Before a long-term storage, we recommend the following measures:

Remove dirt, dust, and plant remains from the machine.

Repair damaged areas on painted parts.

Drain the gasoline from the fuel tank and the carburettor (additional instructions included in the engine operating
manual).

Lubricate the machine as recommended in
Table 10
.

Check the tyre pressure and inflate the tyres to MAX pressure.
Prevent access of unauthorized persons to the machine. Protect the machine against weather influences, but do not use air-tight
protection due to increased corrosion.
70
In highly dusty conditions, check and clean every hour!
33
re
vi
ze
1
2/
20
15