EN
6
-Adjust the position of the fixation on the
tube of the machine, in order to obtain a
good balance between the rear and the
front of the machine.
-If you use the machine with nylon head,
you must adjust the belt in a way that the
distance between the ground and the nylon
head is in between 0 and 300 mm.
-If you use the 3-teeth blade, you must
adjust the security harness in a way that the
distance between the ground and the blade
is between 100 and 300 mm.
Tools types
Safe and economical operations require
that you use the appropriate type of cutting
tools.
The 3-teeth blade and the nylon head
provided with the machine are good for the
majority of uses. Use only original spare
parts because those are specially made for
your model by the manufacturer.
Never use steel wires or other materials.
Mounting the nylon head
Screw on the nylon head on the central bolt
(M8, left-handed thread) and tighten it
rightly.
Insert a screwdriver into the hole on the
upper side of the angle gearbox to prevent
the shaft from turning.
Make sure that the nylon head is
completely and safely locked.
Mounting the three-teeth blade
Place the 3-teeth blade on the centring
washer (with the writing up).
Put back the big washer in order to
maintain the blade.
Insert a screwdriver into the hole on the
upper side of the angle gearbox to prevent
the shaft from turning.
Put on the sliding cover, screw on the nut
and tighten it rightly.
Tightening torque: 30 Nm.
Make sure that the blade is completely and
safely locked.
Make sure that all different parts of the
cutting tool are securely fastened as above.
If the blade is not correctly
positioned it can involve SERIOUS
DAMAGE
AND
INJURY
TO
PERSONS AND PROPERTY.
MAIN PARTS OF THE
BRUSHCUTTER:
1.
Mixture tank.
2.
Gas control with STOP button.
3.
Carburettor / air filter.
4.
Handlebar.
5.
Handlebar holder.
6.
Gas control lever.
7.
Transmission axle.
8.
Gearbox.
9.
Cutting tool.
10.
Safety guard.
Never use nylon heads and/or
three-tooth blade other than those
provided by the manufacturer. Always
use tools in perfect condition, free of
deformation, dents, broken or deformed
teeth that could cause the breakage of
the cutting tools.
In high-speed rotation, parts could be
projected at very high speed and could