The desk may need to be recalibrated if the screen is not showing the correct height—for instance
the display reads 43 inches but is in fully lowered position. To do this, press the DOWN button on
the control panel until the base reaches its lowest position. Measure the distance from floor to the
top surface of the desktop. If the number on the LED display does NOT match your measurement,
follow these steps:
Press and hold the DOWN button until the LED display reads “RST”. Press and hold the “M”
button until the LED displays the flashing height. Use the UP/DOWN buttons to change the value
of the starting height so that it matches your measurement. The display will return to “RST” in
about 5 seconds.
Finish the reset process by pressing and holding the DOWN button again until the desk lowers a
little bit more, slightly rises, and stops. Release the button. The new starting height value is saved
and your desk is now ready to use.
NOTE:
The LED display has a +/- 0.1 tolerance.
Recalibrating
1
2
3
4
M
If the legs have no response, your desk may need to be reset. Follow the initial setup instructions
and ensure all connections are in the correct location and fully plugged in. If the legs are rising
slowly, check the input power connection to make sure it’s secured correctly. If any errors
continue, please contact Vari.
Troubleshooting and Reset
Press and hold the “M” button (about 8 seconds) until the LED display switches to “S-” and then
to “LOC”. Release the button.
Control Panel Lock
1
2
3
4
M
1
2
3
4
M
Press and hold the “M” button (about 8 seconds) until the LED switches from “LOC” to the height
display. Release the button.
Control Panel Unlock
8
