4
VL5LED WASH
QUICK START GUIDE
MENU OPERATION
LCD DISPLAY AND MENU SYSTEM
The VL5LED Wash Luminaire’s LCD Display and Menu System provide local control for accessing the following
fi xture’s settings:
• Address – to set the DMX address
•
Confi gure – various parameter settings, set LED,
movement, display, reset defaults
•
DMX – change the map, set address,
•
Fixture – fi xture status, ReCal, reboot, software version,
view fi xtures hours, crossload, service
•
Test – to test functions of parameters
•
Manual – to set the intensity, all functions
The menu system is controlled at the Menu Display available at
the enclosure input panel. If there are multiple luminaires in a
system, any settings or changes would need to be made at each
LCD Menu as desired.
MENU CONTROLS
The menu system is controlled by an [ESC], [OK] and four Arrow (
▲▼◄
►
) buttons.
MENU OPERATION
The LCD Display Menu system consists of several categories. Use the Menu Buttons to access and make changes
to the menu items. When the desired menu item is reached, press the desired Menu Button to display the menu
options and to navigate and confi gure the menu options as required.
To navigate and access menu setting/selections:
Step 1.
Make sure unit is powered and turned on.
Step 2.
Press [ESC] to access menu categories.
Step 3.
Use four Arrow (
▲▼◄
►
) buttons to navigate through the various options and settings.
Step 4.
Once menu item is reached, press [OK] to access the menu item parameters.
Step 5.
Make changes to parameters as desired.
Step 6.
Press [OK] button to accept changes.
OTHER LCD DISPLAY FEATURES
LCD MENU BATTERY OPERATION
The LCD menu system utilizes a battery powered system for operation when the luminaire is not connected to
power. The primary purpose of this mode is to allow basic setup and confi guration of the luminaire.
To enable the battery operation of the menu system:
Step 1.
Press + three seconds to activate display!
Step 2.
Once enabled, the menu will function as normal with only the following sub-menu sections active:
• Address
• Confi gure
• DMX
• Fixture
NOTE:
Any commands that require full power (calibrate, etc.) will be ignored while the menu system is in bat-
tery operation mode.
Step 3.
To exit battery mode, press [ESC] + [OK] for three seconds.
ESC
Used to access
main menu, exit, or
return to previous
menu item
OK
To select or change
a setting or data value
LCD Display
Shows
all data and luminaire
settings
