3
Quick Start Guide
VL2600
ProfiLe, SPot, WaSh
02.1711.0022 reV B 09/21
FIGURE 1.
INSTALLING bRACKETS ON LUMINAIRE ENCLOSURE
Press up to
Locked
install or release
Locking
Mechanism
Example Truss Hook and Mounting Hardware
(not included, sold separately)
Mount
Bracket
Locking
Mechanism
Keyed Hole
Mount Bracket
Fit bracket’s keyed hole and locking mechanism
over raised mounting buttons and slide forward
to lock.
BRACKET ORIENTATION
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows:
a. Loop safety cable at least once around safety cable anchor point rod.
b. Loop safety cable at least once around truss/pipe and secure around pipe.
Step 4. Make sure tilt and pan locks are disengaged so luminaire moves freely.
Step 5. Connect power and data cables.
650mm
(25.6 in)
NOTE: Truss hooks shown
are sold separately. Truss
and pipe by others.
The safety cable anchor
point is tested and is in
compliance of the
following safety standards:
- IEC / EN 60598-1:2015
SAFETY CABLE:
Recommended for
hanging installations.
May be required
by local codes. Safety
cable is sold separately.
Safety Cable
Anchor Point