background image

8

SAFETY WARNINGS AND NOTICES

When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
For indoor, dry locations only. Do not use outdoors. Exposure to rain or moisture may damage fi xture unless it is suitably IP rated.
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
Not for residential use. Do not use this equipment for other than intended use.
Refer service to qualifi ed personnel. This fi xture contains no user serviceable 
parts.
Prior to fi rst use, carefully inspect unit for damage from shipping. 
Installation and operation to be performed by qualifi ed personnel only. 
Use safety tether when mounting.
Install only in locations with adequate ventilation of at least 50cm clearance from adjacent surfaces.
Note distance requirement(s) from combustible materials or illuminated objects.  Do not mount near gas or electric heaters.
Ensure that ventilation slots are not blocked.
Ensure that the voltage and frequency of the power supply match the power requirements of the fi xture.
The fi xture must be earthed/grounded to the appropriate conductor.
Do not operate fi xture outside the ambient temperature range of -5 to 45°C.
Do not connect the fi xture to any dimmer pack.
New fi xtures may emit a chemical odor due to the manufacturing process. This odor will dissipate over time.
Prior to each use, carefully inspect power cables and replace any damaged cables.
Exterior surfaces of the fi xture are hot during operation. Take appropriate precautions.
Power down the fi xture when not in use. Continuous use of the fi xture may shorten the lifespan. 
Clean fi xture regularly, particularly when working in a dusty environment.
Never touch power cables or wires while the fi xture is powered on. 
Avoid entangling power wires with other cables.
In the event of a serious operating problem, immediately discontinue using the fi xture.
Never turn on and off  the unit time after time.
The housing, lenses, and/or the ultraviolet fi lter must be replaced if they are damaged.
Disconnect mains power if the fi xture is not used for a long time.
Original packing materials can be reused for transporting the fi xture.
Do not look directly at the light beam while the fi xture is on.

SAVE THESE INSTRUCTIONS.

WARNING: Refer to National Electrical Code® and local codes for cable specifi cations. Failure to use proper cable can result in damage to 
equipment or danger to personnel.

CUSTOMER SERVICE

If you have any questions regarding this product, please contact Customer Service at +1-214-647-7880 or via e-mail at 

entertainment.

service@signify

.

LIMITED 2-YEAR WARRANTY

Vari-Lite off ers a two-year limited warranty on its control products against defects in materials or workmanship from the date of delivery. 
A copy of Vari-Lite two-year limited warranty containing specifi c terms and conditions can be obtained from the Vari-Lite website at 

www.vari-lite.com

 

or by contacting your local Vari-Lite offi

  ce.

5014592

AMERICAS

10911 Petal Street
Dallas, TX 75235
Tel: +1 214-647-7880
Fax: +1 214-647-8039

ASIA

Room 1201, Freetown Tower D
E 3rd Ring Rd S, 58
Chaoyang Qu
Beijing Shi, China
Tel: +8610-58674776
Fax: +8610-58674775

B-1-27, Dataran Cascades, No. 13A
Jalan PJU 5/1
Kota Damansara PJU 5
47810 Petaling Jaya
Selangor, Malaysia
Tel: +60 3-7611 7302

EUROPE

Rondweg Zuid 85
Winterswijk 7102 JD 
Netherlands
Tel: +31 543-542516
Fax: +31 543-542513

24 Sovereign Park
Coronation Road
Park Royal, London
NW10 7QP
United Kingdom
Tel: +44 020 8965 3209

© 2020 Signify Holding. All rights reserved.

All trademarks are owned by Signify Holding or their respective owners. The information provided herein is subject to change, without notice. Signify does 

not give any representation or warranty as to the accuracy or completeness of the  information included herein and shall not be liable for any action in re-

liance thereon. The information presented in this  document is not intended as any commercial offer and does not form part of any quotation or contract, 

unless otherwise agreed by Signify. Data subject to change. 

Содержание EVENTPROFILE VL800









Отзывы: