Vari Lite BeamLine VL800, Быстрый старт

Страница: 7 / 16

88-105-7290-00 6
Connecting Power and Data
Connecting Power
The luminaire requires standard AC power distribution from 200-240 VAC, 50/60 Hz. Current required depends on the AC
supply voltage and product model. Refer to “Current vs. Voltage” on page 7 for all models covered in this manual.
Note:
The mating Neutrik® powerCON® True1 connector is supplied; however, you will need to purchase or construct a
cable appropriate for your application. Available power input cables is found in “Replacement Items/Accessories” on page 8 .
Figure 2: Power Connector
Depending on the application, the luminaire’s AC input cable may require a different connector. If required, install a new
connector meeting your requirements using the following wire color code reference:
WARNING:
DO NOT connect to three-phase service in countries with 240 volt power. AVERTISSEMENT: NE PAS se
connecter au service en trois phases dans les pays avec puissance de 240 volts.
For single-phase power at 240 volts RMS:
For three-phase power at 200 volts RMS:
WARNING:
It is not recommended to power any VARI
❋
LITE luminaire from a dimmer - even in 'NONDIM' mode. Dimmer
and non-dim modules are not suitable sources of power because their output modifies the AC wave form. This may work for
a short time, but will eventually result in power problems, luminaire mis-operation and/or failure and may void the
luminaire’s warranty.
AVERTISSEMENT: Il n'est pas recommandé pour alimenter un luminaire VARI
❋
LITE d'un gradateur
- même en mode 'NONDIM’. Modules de gradation et non sombres ne sont pas des sources appropriées de pouvoir parce que
Wire* Connection
Green/Yellow AC Ground
Blue AC Neutral
Brown AC Line
* International (Harmonized) Standard
Connection Pin
AC Neutral X
AC Line Y
Ground (Earth) G
Connection Pin
Phase 1 X
Phase 2 Y
Ground (Earth) G
AC Power Input
3-Pole Neutrik® powerCON TRUE1 for AC Input Power
Neutrik® powerCON TRUE1
AC Input Connector
X
Y
G
X
Y
G