2
User ManUal
912400575001UM
w w w.VA R i - L i T E .c o M
PREFAcE
1.
aBOUT THIs ManUal
The document provides installation and operation instructions for the following products:
•
VL800 EVENTPAR RGBA
Read all instructions before installing or using this product. Retain this manual for future reference.
Additional product information and descriptions may be found on the product specification sheet.
2.
InClUDeD ITeMs
Each VL800 EVENTPAR luminaire includes the following items:
•
VL800 EVENTPAR RGBA
•
Quick Start Guide
3.
saFeTY nOTICes
•
Unpack and check carefully for damage from shipping before using the unit.
•
Do install and operate by operator.
•
Use safety tether when mounting.
•
Install only in locations with adequate ventilation of at least 50cm clearance from adjacent surfaces.
•
Ensure sure that ventilation slots are not blocked to prevent overheating.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements
of the unit.
•
It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
•
Maximum ambient temperature T
A
: 40°C minimum ambient temperature T
A
: 0°C. Don’t operate it where
the temperature is higher than this.
•
Do not connect the device to any dimmer pack.
•
First run, there will be smoke or smells, and all disappearing a few minutes later.
•
Make sure there are no flammable materials close to the unit while operating, as it is fire hazard.
•
Look over power wires carefully, replace immediately if there is any damage.
•
When in use, fixture surface temperature may reach up to 65°C. DO NOT touch the housing.
•
Never run on for a long time lest shortening lifespan.
•
Do not operate in dirty and dusty environment, also cleaning fixtures regularly.
•
Do not allow children to operate the fixture.
•
Do not touch any wire during operation as there might be a hazard of electric shock.
•
Avoid power wires together around other cables.
•
In the event of serious operating problem, stop using the unit immediately.
•
Never turn on and off the unit time after time.
•
The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
•
Do not open the unit as there are no user serviceable parts inside. Never try to repair the unit by yourself.
Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest
Authorized Service Center.
•
Disconnect the mains power if the fixture is not used for a long time.
•
Do use original packing materials once transport it again.
•
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
•
Do not look directly at the LED light beam while the fixture is on.
•
To protect the machine, power off 10s rear can electrify.
Содержание BeamLine VL800
Страница 1: ...VL800 EVENTPAR RGBA User Manual...
