User Manual: UM50589-EN
Optica 20 series
Revision: 4.0
Date of release: 2019-01-23
14/20
www.vareximaging.com
F.
Measuring tape for determining SID. Pull out the lever and place it against the designated
surface (e.g. table, wall stand, etc.). The SID value can be read on the measuring tape where
it exits the collimator enclosure. The maximum value to be measured is 2m / 80”.
WARNING:
Pulling out the measuring tape beyond the maximum value can cause breakage and/or
distortion of the tape.
Always guide the measuring tape back to its start position, sudden release of the
measuring tape can cause damage to humans, the tape itself and/or collimator housing.
G.
Accessory rails, suitable for holding maximum of two accessories with outside dimensions of
176x176mm and a maximum thickness of 2mm in the cut-out of the rail.
H.
Lock spring for accessories; slightly pull out the spring and remove the applicable accessory.
CAUTION
Be careful when handling the lock spring, over-elongating the spring can cause
permanent damage to the lock spring.
H
G
1
F
