18
19
Before replacing the vermiculite plates and the base slab, adjust the fi re-
place insert until it is straight and fl ush with the front of the fi replace.
|
Adjust the four screws in the bottom of the insert, as shown.
|
A spirit level may be used to ensure that the insert is level.
|
You can also fasten the insert to the bottom of the fi replace with a
couple of frame screws, concrete screws or the like, via the two large
holes in the base.
7
Adjustment
8
Completion
The fi replace insert must be reassembled before it is ready for use.
|
Replace the vermiculite plates and the base slab in the insert, in the
order shown.
|
Fill in the top 2-3 cm with fi replace mortar to fi x the tubing in place.
Your fi replace insert is now ready for use.
See the sections on Lighting and Stoking.
DANSK
|
ENGLISH
|
DEUTSCH
|
FRANÇAIS
1
2
3
The fi replace insert can now be connected to the fl ue.
|
Pull the fl ue in through the rear opening in the fi replace insert.
|
Fasten the tubing in the fi replace insert by folding up the fl aps, so
that the tubing is held fi rmly in place.
Fitting
|
5
Positioning
You can now fi t the fi replace insert.
|
Remove the vermiculite plates and the base slab from the insert in the
order shown.
|
Push the insert into position in the fi replace.
6
Connecting
1
2
3
4
