background image

Blocked tube

General fault

Water out

Alarm mute 

LED

Alarm mute 

button

Setting 

Control 

Knob

Battery low 

or charging 

(not indicative of 

charge level)

Disposable 

Water Path 

faulty or 

absent

Low Flow 

Circuit 

Installed

Vapor Transfer  

Cartridge fault

 

Gas supply 

fault

Run/Stop 

Status LED

Run/Standby 

button

Q U I C K   R E F E R E N C E   G U I D E

High Flow 

Circuit 

Installed

This guide provides you with basic instructions on how to set up and operate 
the Precision Flow® Heliox. Before operating the Vapotherm Precision Flow® 
Heliox, please review the Instructions For Use which can be found at our 
website www.vapotherm.com and on the USB drive provided in the Start-Up 
Kit.

Содержание Heliox Precision Flow

Страница 1: ...tridge fault Gas supply fault Run Stop Status LED Run Standby button Q U I C K R E F E R E N C E G U I D E High Flow Circuit Installed This guide provides you with basic instructions on how to set up and operate the Precision Flow Heliox Before operating the Vapotherm Precision Flow Heliox please review the Instructions For Use which can be found at our website www vapotherm com and on the USB dri...

Страница 2: ...ADY The internal battery backup is not fully charged The unit would not run on battery for the full rated time in the event of a power failure No action is necessary BATTERY FLASHING The unit is running in BATTERY mode Gas flow and blending continues without heat or water circulation AC power is disconnected Reconnect AC power BLOCKED TUBE FLASHING High back pressure Obstructed or kinked cannula d...

Страница 3: ...previous temperature Silence alarm and wait for temperature to drop Temperature 2 set point Very low water temperature after bag replacement Silence alarm and wait for temperature to rise INDICATIONS WARNINGS AND CAUTIONS Primary Indications The Precision Flow Heliox is intended to add warm moisture to breathing gases from an external source for administration to a neonate infant pediatric and adu...

Страница 4: ... when the set variables are reached Place the cannula on the patient Once the unit has reached at least 33 C connect to delivery tube The unit should not be placed in Standby mode for extended periods of time For pauses in therapy keep unit in RUN mode remove cannula from the patient and set the parameters to the lowest available setting To reinitiate therapy before cannula is placed on patient cl...

Отзывы: