OPERATING TIPS
We have provided the following operating tips so that you can maximize the
effectiveness of your new VaporLux equipment.
1. Always fill the boiler with the water bottle or use a pitcher and funnel,
never place the unit directly under the tap when filling, water can
migrate into the machine and cause an electrical short circuit.
2.Do not overtighten the filler cap. The cap should only be finger tightened
until it is snug. If the cap is overtightened, the next time you use your
machine, vapor will leak from the cap, Should this happen, there is an
O ring attached to the handle of your machine. These O rings are made
of high temperature material and regular O rings will not work.
3.You can use hot water to fill the boiler, hot water will decrease the
heating time required to come up to operating temperature.
4.Wipe the top of the waterfill orifice on the machine after filling, you
will then be able to tell if the filler cap is sealed correctly.
5.Check the voltage of your power source before plugging in the machine.
Not enough voltage will cause stress on the internal components and
possibly cause equipment failure. Too much power is equally dangerous
to your machine. A surge protector can be placed between the outlet
supply and the extension cord to protect against spikes and surges.
6.When you plug in the VaporLux extension cord, make sure the lighted
end of the cord is lit. If it is not, check your power source.
7.Do not pull the machine by the cord.
8.Always make sure the on/off switches are in the off position before
plugging in the machine.
9.Never turn off the machine by unplugging it, always turn off the switches
first.
10.You can heat the machine ahead of time so that when you need to
clean, the machine is ready for operation.
11. When you are done cleaning, turn off and unplug the machine, do not
leave it on overnight or for extended periods.
12.If you are not going to use the machine for an extended period, drain
the boiler.
13. When operating, do not pull the machine by the hose.
14. Before refilling the machine, make sure there is no pressure in the
boiler before you remove the filler cap. Pressure in the tank can be
released by pressing the vapor button on the hose handle.
Start Up and Shut Down
