www.fmiproducts.com
125784-01D
17
INSTALLATION
Continued
Figure 21 - Main Screen
Figure 22 - Configuration Menu
Figure 23 - Off Highlighted
RE-PAIRING
IMPORTANT!
This appliance is shipped
with the remote control and control module
(receiver) paired. However, if more than one
Copreci brand electronic ignition system is
to be used within a home or showroom,
all
but one appliance must have the remote
control and control module re-paired in order
for each appliance to operate on a unique
frequency. For multiple appliances, on all but
one follow the instructions under
Re-Pairing
on page 17 before moving to
Installing Logs
on page 18. For single appliance installations,
skip the RE-PARING section and proceed to
Installing Logs
.
It is helpful to have a flashlight so you can see
the connections as described below. Before
proceeding, locate the yellow/orange S1
button on the control module. You will need
to access this button during the re-pairing
procedure and only have 20 seconds to press
and release it. A small nail or ink pen will also
be useful to press this button (see Figure 17,
page 16).
Press and hold the “Off” button
on the
remote control for 40 seconds. During this
time, the screen will go blank, this is normal.
See Figure 21.
After 40 seconds, the configuration menu
appears (see Figure 22). With ''Pairing'' high-
lighted press the middle ''select'' button. ''Off''
becomes highlighted (see Figures 22 and 23).
Configuration
Select Back
Off
No
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:04
Pairing
Configuration
Change
Back
Yes
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 21:47
Off
Pairing
OFF
Button
Fri 20:45
Lock
Menu
On
OFF
°F
75
u
Configuration
Select Back
Off
No
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:04
Pairing
IMPORTANT! Be prepared to press the S1
button as noted in the beginning of this sec-
tion. After the next step, you have only 20
seconds to push (press and release) the S1
button (yellow/orange) in the control module
(see Figure 17).
NOTE:
The control module may be turned dif-
ferently than shown in this figure. Look for the
matching text on the control module to help
locate the small yellow / orange S1.
SELECT
Button
Configuration
Select Back
Off
No
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 22:04
Pairing
Configuration
Change
Back
Yes
Yes
0.5°C
Thermostat
Programming
Gap Temp
Fri 21:47
Off
Pairing