Vantage Controls Axium 450 Series, Инструкция по эксплуатации

Страница: 13 / 32

13
Advanced IR Control
FIG 3
IR routing – discussed in Typical System confi guration” on page 11 is used to address centrally located source
equipment.
When multiple same brand / model source equipment is used steps must be taken to isolate the radiated IR from
interfering with their discrete operation. This may be achieved by either installing in different cupboards / locations or
by using IR blockers over the IR emitters. The IR blockers are the preferred solution since cupboard doors are often
left open.
Fig 3 shows a typical installation where several SAT receivers and tuners are required. The dashed lines enclosing the
source equipment represent IR isolation.