Vanpee LED neon flex, Руководство пользователя

Страница: 12 / 16

Side �at DIY screw front connector kit instructions
The correct cutting way, R= 90
R>90 or R<90 , is incorrect °
Wave cutting is incorrect
LED Neon � ex
Anti-skidding Clip
1.Place the anti-skidding clip on
the very end of the tubing with
the 2 tiny tabs that are pointing
inwards still touching the end of
the material and crimp in place.
2.Line up the aluminum
mounting piece so the screw
holes face the plug and slide on
over the anti-skidding clip.
Aluminum mounting piece
R
L
2
4
V
+
BU
SI
L
2
4
V
Cutting mark
R
+
R
L
2
4
V
+
Rubber gasket
6.Screw the front connector
to the aluminum mounting
piece.
5.Carefully insert the pins of the front connector
into the gap you created behind the PCB.
5.Carefully insert the pins of the front connector
into the gap you created behind the PCB.
7.Check the connection to ensure it is tight and that there
are no gaps between the Neon Flex tube and the front connector.
User Manual version 1 | page 10
Screw Blank end Rubber gasket
Anti-skidding clip
Aluminum mounting piece
Side �at DIY screw end cap kit instruction
Rubber gasket
Silicone Rubber
Silicone Rubber
End Cap
Front Connector
PCB
4.Put 100% clear silicone
on the surface of rubber
3.Insert the rubber gasket along the
slit into the pin of the front connector
gasket