STONEVAC AM
120V
25799 Jefferson Ave.
Murrieta, CA 92562
1-800-VANIMAN (826-4626)
www.vaniman.com
SV-AM-07/23 Page 2
4. When you are ready to use your StoneVac, press the button on the front of the unit labeled
START/
STOP (Fig. 1)
. Once pressed, the motor will begin to run at the lowest available speed and the green
LED indicator will illuminate on the front of the StoneVac.
5. While the motor is running you can increase suction
by pressing the
SPEED UP
button, or decrease
suction by pressing the
SPEED DOWN
button until
you find an an acceptable level of suction for your
application.
6. While the StoneVac Brushless SC can be controlled at
the unit's front control panel, it also can be controlled
remotely with one of Vaniman's remotes. To use a
remote with the StoneVac Brushless SC, start by
setting the desired suction level for your application
by starting the motor, increasing or decreasing the
speed of the motor, then stop the motor.
7. Plug the remote into the
REMOTE PORT
(Fig. 2) on the back of the unit then press the
MANUAL/
REMOTE
button on the front of the unit (Fig. 1). The blue LED indicator on the front control panel
will illuminate signifying the unit is being controlled by the connected remote(s). Test this by flipping
your remote switch into the
ON
position and the StoneVac will start running at the speed you set it
at in step #6.
MAINTENANCE
1. Cleaning the Filter
- When a noticeable drop in suction occurs in the unit, it is time to clean the filter.
To use the self-cleaning feature of the StoneVac, push and hold the Power switch in the “CLEAN”
position for several seconds. Optimum cleaning takes place in within 5 seconds. For best results,
wait an additional 10-15 seconds with the Power switch in the
“OFF”
or center position, this allows
the dust cleaned from the filter to fall into the dust bin before turning the unit on again.
2. Emptying the Dust Bin
- Depending on usage, the unit will need to be emptied at different intervals.
To check the level of dust in the bin, open the door and observe the dust level. To empty, open the
door and slide the bin from the unit. Pull the edges of the bag together to close the bag for disposal.
Replace the bag with a Vaniman replacement and carefully slide the dust bin back into the unit.
Replacement bag re-order number
P/N 97002
(pack of 12).
3. Servicing or Replacing the Filter Cartridge
- Regularly check the filter to make sure it is secure
and properly seated against the filter mounting/sealing plate. Periodically, the filter cartridge will
become worn or clogged beyond the use of the “CLEAN” feature. In cases when dust collector
usage is heavy, changing interval may be as frequent as 3-6 months. To replace the filter, follow the
instructions above to remove and empty the dust bin. With the dust bin removed, reach underneath
the Filter Cartridge and unscrew the filter retaining nut. Remove the nut and washers and pull the
filter downward then forward out of the unit. Replace the filter with a new filter cartridge then reverse
removal instructions for proper installation. Filter Cartridge re-order
P/N 97001
.
NOTE:
Be sure to replace the rubber washer
FIRST
and the metal washer
SECOND
. Securely fasten
the filter retaining nut. Improper installation may cause dust to pass into the air.
Fig. 2
