EZCT S2 USER’S MANUAL
REV 3
8
2.5
Replacing the Thermal Printer Paper
The roll of thermal paper is housed inside a dispenser underneath the printer cover. To replace
the paper, follow the steps below:
•
Unscrew the two large printer cover screws and remove the printer cover.
•
Remove the leftover thermal paper roll from the paper holder.
•
Unroll the new thermal paper roll.
•
Feed the thermal paper into the slot between the paper pocket and the rubber roller.
The printer will automatically pull the paper under the thermal head.
•
Place the paper roll into the paper holder.
•
Lift the thermal head and align the thermal paper if necessary.
•
Re-install the printer cover.
NOTE
Thermal paper has a chemical coating on one side of the paper. This side should be
facing the thermal print head. Incorrect paper loading may result in blank output on
the thermal paper.
The thermal paper will show a red stripe to indicate that the roll is about to run out
of paper.
2.6
Computer Interface Ports
The EZCT S2 features one USB and one RS-232C PC interface port. A Windows-based “Current
Transformer Analysis” software application is supplied with the EZCT S2. For further
information, please see the software user’s manual.
Содержание EZCT S2
Страница 23: ...REV 3 EZCT S2 USER S MANUAL 19 Figure 5 Typical EZCT S2 Tabulated Report Printout...
Страница 25: ...REV 3 EZCT S2 USER S MANUAL 21 Figure 6 Typical EZCT S2 Graphic Report Knee Point Marker...
Страница 31: ...REV 3 EZCT S2 USER S MANUAL 27 Figure 7 Typical Internal Test Record Directory Printout...
Страница 37: ...REV 3 EZCT S2 USER S MANUAL 33 Figure 8 Typical EZCT S2 Flash EEPROM Test Plan Directory Printout...
