USER MANUAL
24PCS OUTDOOR LED WALL WASH LIGHT
Easy for power connection.
Ⅴ
INSTALLATION INSTRUCTION
Before plug-in the power, please make sure the voltage, frequency of the light are
correspond to the power. And ensure the grounding line of the light working reliable.
You can distinguish the different power cords as below:
Color of the Power Cord
Connection
Brown
Live line
Blue
Neutral/Null line
Yellow green
Earth line
1. Signal Connection
This light provide 3 pins cannon seats, Pin1 for signal ground, Pin2 for signal-, Pin3 for
.
DMX-IN DMX-OUT
The controller, light and light will be connected by 3 pins signal cables one by one.
You can connect the output of the controller with input of the first light, and connect the
output of the first light with the input of the second light in the DMX control mode, and so
on one by one. And please connect the output of the last light with the terminal seat. You
can don’t need the controller and circuit terminal seat in the master/slave controller mode.
You can use one 120Ω& 0.25W resistance to insert into and weld the pin2 & pin3 of one
male cannon plug to make the circuit terminal seat. The circuit terminal seat can avoid
DMX-512 signal reflex and interference effectively.
If the output of your controller is using 5 pins cannon seat, please use 5pins into 3pins
signal change cable.
2. Installation Method
The light can be placed on the solid plane places, then loosen the screw on both sides of the
handles to adjust the right project angle. Please pay attention the places are
non-flammable.
Install the clamp into the hole of the handle, and hang it on the truss then. You can
adjust the right project angle through the screw of the both sides of the light. It’s
important that you have to use one or more protection measures to prevent the light will
fall, such as the safety rope. You can buy the clamps and safety ropes from our
-6-
DMX IN DMX OUT DMX IN DMX OUT DMX IN DMX OUT
DMX Controller
Circuit Terminal Seat
05
03
05
04
