VG-ERS200A 200W LED Profile Spot Light User Manual VG-ERS200A 200W LED Profile Spot Light User Manual
5.
The use of gobo frame
Take out the gobo frame ,loose the screws, insert the gobo and lock the screws again
Insert the gobo in the slot
6.
Use iris
Iris is not included when the projector leave factory, user can purchase the iris if needed
Loose the screws and insert the iris.
7.
Replacing fuse
Before replacing the fuse, unplug mains lead.
Procedure:
Step1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from housing
(anti-clockwise)
Step2: Remove the old fuse in the fuse holder
Step3: Install the new fuse in the fuse holder.
Step4: Replace the fuse holder in the housing and fix it.
8.
Focus
The objective lens cylinder is usually shrinked before leaving factory after connect the
projector to the mains, user may loose the screws and pull out the lens cylinder, till the
white light output circular is clearly presented, locking tightly the two screws again.
When the projection distance is changed, user can follow previous operating steps
and focus the projector.
09
08
