Vandersteen Audio
7
Model lC Operation Manual
VANDERSTEEN AUDIO
116 West Fourth St.
Hanford, CA 93230
(559) 582-0324
The open areas of the end trays must face
away from the speaker. The flat surfaces
of the end trays must be against the
speaker.
SPEAKER CARE
MAINTENANCE
The appearance and performance of the Model lCi+
The Model 1Ci+ grille cloth can be vacuumed
is enhanced by observing a few precautions and perform-
using a brush attachment that will not snag the cloth. The
ing some simple maintenance.
top should be treated as a piece of fine furniture. The wood
The input terminals on the Model lCi+ should
top are lacquered at the factory and can be maintained with
be cleaned periodically with alcohol or a solution
a light application of Pledge or a similar product.
made specifically for cleaning electrical contacts. A cotton
Care must be taken that objects that could mar the
swab with a small amount of cleaning solution on it can be
finish are not placed on top of the speaker. Do not expose
used to clean inside the screw openings. Other connection
the speakers to excessive heat or direct sunlight, which can
points in the system should be cleaned as recommended by
damage the fit and finish of the veneer.
the equipment's manufacturer.
SERVICE
In the unlikely event that one of your Model lCi+ should
ever require servicing, please follow these procedures.
1.
Verify that the problem is in the speaker by switching
the left and right speakers. If the problem follows the
speaker, it is in the speaker. If the problem does not
follow the speaker, it is in the system before the speaker.
2.
Contact Vandersteen Audio, describe the problem and
the steps you have taken to isolate the problem to the
speaker. A Return Authorization Form will be sent to you.
PACKING INSTRUCTIONS
To prevent physical or cosmetic damage, always pack
the Model lCi+ in its original box prior to transportation or
shipment. Please follow these instructions when packing the
Model lCi+.
1.
Turn the speaker up-side-down on a carpeted or padded
surface that will not scratch the top.
2.
Remove any base that is attached to the speaker.
3.
Pull the plastic bag down over the speaker.
4.
Slide the inner liner over the speaker.
5.
Fit one of the end trays into the end of the inner liner
with the open area of the end tray facing away from the
speaker.
6.
Holding the flaps out, slide the outer box over the inner
liner all the way to the floor.
7.
Carefully turn the box and speaker right-side-up.
8.
Close the plastic bag and place the remaining end tray
into the inner liner as was done in step 4.
9.
Close the flaps on the outer box and seal with strong tape.
3.
When you receive the Return Authorization Form, return
the damaged or defective speaker to Vandersteen Audio
packed in its original box. Include the completed Return
Authorization Form in the box with the speaker.
End Tray
Plastic Bag
Inner Liner
Outer Box
Do not ship your speakers in anything other than an original box. Replacement boxes
and packing are available from Vandersteen Audio for a nominal charge.
