www.vanco1.com
800.626.6445
7
CONNECTION DIAGRAM
CONNECT AND OPERATE
1. Connect a source such as a Blu-Ray Player, game console, A/V Receiver, Cable or Satellite Receiver, etc.
to the HDMI input
2. Connect the Cat5e/6 runs (home run cabling recommended) to the UTP output(s); connect to the
EVRX2006 or EVWP2006RX receiver (sold separately)
3. Connect displays such as an HDTV or HD Projector to the HDMI output of the EVRX2006 or
EVWP2006RX receiver
4. (Optional) Connect a display such as an HDTV or HD Projector to the HDMI output of the EVSP1017; or
connect an additional EVSP1017 or other splitter to cascade to create additional outputs
5. For power, connect the provided power supply
IR RX
IR TX
Single HDMI Source
HDTV
HDTV
HDTV
HDMI
HDMI
Use with EVWP2006RX
or EVRX2006
(Sold Separately)
Cat5e/6
HDMI
Cat5e/6
Cat5e/6
At this point the display connected should display the source signal connected to the extender set. If no
signal is being displayed, connect a shorter Cat5e/6 cable (jumper or patch cable). If a display is having
difficulty receiving a signal, access the display’s menu and adjust the resolution (lowest to highest until signal
is displayed). A 24 Hz vertical refresh rate may work better than 60 Hz or higher. Use the source remote at
the receiver emitter to test IR functionality. If the IR remote function is not responding, check the emitters to
ensure they are placed correctly and are plugged into the correct IR jacks on the Extender set receiving and
transmitting units.