www.vanco1.com
800.626.6445
9
IR CONTROL
The EVMX44VW allows for IR pass-through to control the connected sources at the display locations. The IR
signals are routed, so the sources are only controllable at a display location if the source is switched to that
output.
IR Emitters:
Connect the IR Emitters (Blasters/TXs) to the “IR OUT” port on the back of the matrix unit, ensure that the IR
Emitter is placed on the corresponding source (For example, IR OUT port 1 = HDMI input 1)
IR Receivers:
Connect the IR Receivers (RXs) to the “IR IN” port on the back of the matrix unit, ensure that the IR Receiver
is routed to the corresponding display (For example, IR IN port 1 – HDMI output 1)
NOTE: Infrared receiving areas of source devices can be located by shining a flashlight onto the front of the
device – the sensor should be able to be seen through the plastic as a small, round object inside. Place the IR
Emitters around or near this area with the tip of the IR emitter near the IR sensor of the source. IR receivers
should be placed at the display and line of sight, so that an IR remote can be pointed at the pigtail to receive
IR signals.
