www.vanco1.com
800.626.6445
25
7 IR Control
7.1 IR Remote Control
1. Enter/exit standby mode
2. Blinking red when a button is pressed
3. Video source selection buttons
4. Output channel selection buttons
5. Menu buttons:
•
ALL: Select all inputs or all outputs
•
EDID: Enable one or several input sources to manually capture and
learn the EDID data of output device
•
CLEAR: Cancel the current operation, if ENTER has not been pressed
•
ENTER: Confirm the desired operation
Connect IR receiver to the IR EYE port on the back of the EVMX44PRO, the matrix can be controlled by the
included IR remote
Note: The IR receivers which are connected to HDBaseT receivers also can receive the IR signal of the IR
remote, so the matrix switcher also can be controlled by the IR remote at the far-end HDBaseT receivers’
position. The IR remote-control mode can be enabled or disabled by sending RS-232 command “IRRCM[X]
ON.”/ “IRRCM[X]OFF.” ([X]=0~4). Please refer to the 8.3.1 System Control for more details.
