www.vanco1.com
800.626.6445
7
PANEL DESCRIPTIONS
4
1
2
3
6
5
7
9
8
10
11
1. RS-232 Mode Switcher - Option for RS232 pass-through with selections to update firmware (See RS-232
Mode Switcher section)
2. Link Status LED - OFF: No Link; GREEN: Link successful
3. HDCP Status LED - OFF: No HDMI signal (no picture); GREEN: HDMI signal with HDCP; Blinking: HDMI
signal without HDCP
4. Power LED - OFF: No power; RED: DC power present
5. RS-232 - Connect for control via PC or third party control system
6. IR IN – Connect the included IR Receiver (RX) to control the source
7. IR OUT – Connect the included IR Transmitter (TX) to control the display
8. HDMI OUT – Connect an HDMI display
9. HDBT IN – Connect a single Cat5e/6 that will connect to the Transmitting unit (home run cable
recommended with no coupling or patch panels for optimal performance)
10. Ethernet – Connect either an ethernet source such as a switch or router, or connect devices to receive
ethernet, an ethernet source is required to be connected on the Transmitter unit or Receiving unit
11. DC 24V – Connect the included 24V Power Supply (extender set has PoH and requires only one power
supply, connect the power supply to the Transmitter unit OR Receiver unit)
EVEXHDB2-RX (Receiving Unit)
USAGE PRECAUTIONS
1.
System should be installed in a clean environment and has a prop temperature and humidity.
2.
All of the power switches, plugs, sockets and power cords should be insulated and safely connected.
3.
All devices should be connected before being powered on.
4.
The Cat5e/Cat6 terminations for HDBaseT devices recommend a straight-through TIA/EIA T568B
standard
