www.vanco1.com
800-626-6445
12
The Super IR system allows you to control the source that is connected to the splitter, from any display
connected using the Super IR adapters at each display. There are two important things to note when setting
up the IR system:
1. The IR Receiver (IR RX) is always what you point your remote at to send an IR signal. These pigtails are
placed at each display and plugged into the Super IR adapter placed in between the HDMI cable and the
display.
2. The IR Blaster (IR TX) is what sends the IR signal to your source. This pigtail is placed at the source,
either pointed at the source, or placed on the front panel of the source using optional IR TX part #
280720EXT, see below for placement tips.
IR BLASTER (TX)
Plug IR Blaster into IR port on front panel of splitter unit; place blaster in front of the IR eye of the
corresponding source.
There are (2) versions of the Super IR Blaster:
280720
- Super IR Transmitter
(blaster type, to be placed in front of source)
IR RECEIVER
Plug IR Receiver into IR Adapter (see below); place receiver at or near corresponding display.
280721
- Super IR Receiver (block type,
to be placed at display)
IR
280720EXT
- Super IR Transmitter with
extension (small pigtail type, to be placed on front
panel of source)
280721EXT
- Super IR Receiver with extension
(dome type, to be placed at display)
