background image

Opmerkingen:

Amachtstraat 8a    •    7622 AP Borne    •    Tel.: 074 - 266 20 35    •    Fax.: 074 - 266 90 56  •  

K.v.K. Enschede 06075299    •     Bank: ABN-AMRO 42.71.91.297    •    BTW: NL803645600B01    

Artikelnr.:

 

72&

Serie

:

 

/RQJ,VODQG

Type:

%DGGRXFKHPHQJNUDDQVWDDQG

[email protected]    •    www.vanheckbadkamers.nl

De informatie op deze pagina was correct op de datum van opmaak.

Van Heck badkamers is niet verantwoordelijk voor de veranderingen die optreden door verbeteringen aan onze producten

Geen

Geen

Geen

Geen

De informatie op deze pagina was correct op de datum van opmaak

Содержание Long Island Series

Страница 1: ... 71 91 297 BTW NL803645600B01 Artikelnr 72 Serie RQJ VODQG Type DG GRXFKHPHQJNUDDQ VWDDQG info vanheckbadkamers nl www vanheckbadkamers nl De informatie op deze pagina was correct op de datum van opmaak Van Heck badkamers is niet verantwoordelijk voor de veranderingen die optreden door verbeteringen aan onze producten ...

Страница 2: ...and cold inlets This is a stated requirement of Water Supply Water Fittings Regulations 1999 Schedule 2 Section 6 G15 13 2 Before making any inlet pipe connections all supply pipes MUST be thoroughly flushed to remove debris Failure to do so could result in damage or low flow from the mixer unit Water Supply Water Fittings Regulations 1999 Schedule 2 Section 4 G13 1 The fitting of isolating valves...

Страница 3: ...upply Temperature Maximum 85 C Minimum 10 C higher than the maximum required mixed temperature advise 65 C Minimum operating pressure 3 bar Maximum operating pressure 5 bar 251mm 997mm 1095mm 850mm 80mm Min 115mm 191mm 79mm 93mm 755mm 54mm 90mm 74mm Showerhead Place one of the rubber washers into the cone end of the hose and screw to the Showerhead Place the second rubber washer into the other end...

Страница 4: ...wed by the 3 washers and nuts Use the adjusting screws to level the seat when satisfied with the level finally tighten down the bolts Connect the inlet pipes to the seat with the hot on the left and cold on the right Nut Washer Seat Bolts Adjusting screw Bolts Hot inlet Cold inlet Seat Front Finish the floor covering down to a diameter of 75 to 89 mm Remove the 2 screws and pull out the safety cov...

Отзывы: