13
Make sure that you have installed the
camera port tube
as described on page 7 and shown in figure 13.
Assemble the adapters and connect to the camera using the instructions provided with the camera/adapter kit.
Note: Camera kit is not included with this microscope. Please see page 3 for available camera kits.
Remove the
camera port dust cap
, then slide the adapter into the
camera port
(see figure 14)
.
Pull the
prism slider
completely out to divert the image to the
camera port
. The
prism slider
is the silver knob on the right
side of the
head assembly
(see figure 13).
Note: The 1400 Series Microscopes utilize a 70/30 split sliding prism. This split prism diverts 70% of the light to
the camera port and the remaining 30% to the
eyepieces
. This allows the eyepieces to be used while the
prism
slider
is pulled out, although the image seen through the
eyepieces
will be dim when compared to normal use.
When the
camera port
is not in use, be sure to cover with the
camera port dust cap
.
2
1
Using the Camera Port
3
Figure 13
4
5
Figure 14
Using Your 1400
Series Microscope
Trinocular Models Only
