5
Do not leave the laminator power on for extended periods while not in use.
Unplug the machine at the end of the day as a precaution against a possible
fire hazard.
Do not operate the laminator with a damaged power supply cord or plug.
Replace fuses only with same type rated 20, 250V and 1A, 250V fuses.
Contact your dealer for replacement fuses.
There are two (2) EMERGENCY STOP buttons on the laminator, one on each
side. Depressing one of these buttons will stop the rollers.
Specifications...
Operating Speed:
0-10’ per/minute, (3m/min)
Power Requirements
Voltage:
20 amps, 120 VAC, 60Hz
Warm Up Time:
25-30 minutes
Power Fuse:
20 A
Motor fuse:
1A
Maximum Laminating Dimensions
Thickness:
½” (6.35mm)
Width Capacity:
45” (1143mm)
Net Weight:
212 lbs.
Dimensions
56”L x 21”H x 30”D, 142 x 53 x 76cm
Shipping Weight:
370 lbs.
Dimensions
67”L x 40”H x 38”D, 170 x 102 x 97cm
Set-up...
Inspection:
Upon receipt of your ValueLam 4500HC-2, inspect the crate, the machine and all other
contents of the crate for shipping damage. Damage should be brought to the immediate
attention of the delivering carrier.
Power Requirements:
The ValueLam 4500HC-2 is designed to operate on a 110 Volt, 20 Ampere circuit. It will plug
into a standard 110 volt wall receptacle. You must ensure that the circuit is protected by a 20
Amp circuit breaker. Failure to use a dedicated circuit will result in blown fuses and tripped
breakers.
