Valterra Products Go Power! SOLAR FLEX KIT GP-FLEX-100, Руководство пользователя

Страница: 16 / 22

[page 16] | gpelectric.com
INSTALLATION
6. Insert the fuse holder and solar charge controller stripped
cable ends into the butt splice as shown in Fig 4-G
7. Crimp the butt splice fully - test the connection by gently
pulling on both cables
8. Thread the heat-shrink over the butt splice as shown in
Fig 4-H
9. Use the heat gun to shrink the heat shrink over the butt
splice as shown in Fig 4-I
10. Repeat the process for the other fuse holder cable & battery
bank connection.
11. Do not install the fuse at this stage
4.7 CONNECT THE SOLAR CHARGE
CONTROLLER TO THE BATTERY
BANK
It is recommended to connect directly to the battery whenever possible. You can also connect to the converter/charger where
the battery positive and negative wires connect to the converter/charger
1. Clean all corrosion from the battery terminals before proceeding
2. Crimp ring terminals onto the positive and negative cables to be attached to the battery
3. Check the ring terminal crimp connection by gently pulling on the cable and ring terminal
4.
Attach the Negative (Black) ring terminal to the battery bank and tighten according to the battery manufacturers specification
5. Attach the Positive (Red) ring terminal to the battery bank and tighten according to the battery manufacturers specification
6. Check all electrical connections
7. Apply a protective coating to the battery terminals
4.8 INITIAL CONNECTION AND OPERATING
1. Check all electrical connections and ensure all cables are securely fastened
2. Install the Fuse into the fuse holder, ensure the fuse holder is securely fastened
3. Remove the opaque material from the solar panels
4. Follow the solar charge controller user manual and operating steps
Battery Bank
PWM 30
Solar Charge
Controller
3
0
A
Battery Bank
PWM 30
Solar Charge
Controller
3
0
A
Battery Bank
PWM 30
Solar Charge
Controller
3
0
A
Battery Bank
PWM 30
Solar Charge
Controller
3
0
A
FIGURE 4-F
FIGURE 4-G
FIGURE 4-H
FIGURE 4-I