ADCA
VAL
S
TEAM
ADCA
IMI 9.101 E 02.17
CE Marking:
This product has been designed for use on water, steam, air and other gases which are in Group 2 of
the European PED-Pressure Equipment Directive in use and it complies with those requirements.
All the sizes fall within category 2, DN100 pump falling in the category IV and PPA-14 falling in the category III. The
products carry the CE mark.
-
If malfunction of any other equipment or system operation failure may result in a dangerous overpressure, over
temperature or even vacuum condition, a safety device must be included in the system to prevent such
situations.
-
Do not touch the equipment without appropriate protection during working operation because it may conduct
heat if the used fluid is at high temperature.
-
Before starting maintenance be sure that the equipment is not pressurized or hot. Even if upstream and
downstream isolating valves have been closed care should be taken since fluid under pressure may be trapped
between them.
-
The equipments must be used within the working temperature and pressure limits laid down for them, otherwise
they may fail (refer to nameplate and/or IS- Information Sheet).
-
Manual handling of products may present a risk of injury. You are advised to assess the risks taking into
account the task, the individual, the load and the working environment.
-
Before starting work ensure that you have suitable tools and/or consumables available. Use only genuine ADCA
replacement parts.
0,80 kg/dm3
5º Engler
10 bar
0,5 bar
11,2 l
Minimum motive pressure
Pump discharge per cycle DN25 to DN40
APPLICATION LIM ITS POP LC
Minimum density
Maximum viscosity
Maximum motive pressure
0,80 kg/dm3
5º Engler
10 bar
0,5 bar
16 l
25 l
APLICATION LIM ITS POP-S AND PPO-14
Minimum density
Pump discharge per cycle DN80 x DN50
Maximum viscosity
Maximum motive pressure
Minimum motive pressure
Pump discharge per cycle DN25 to DN50
0,80 kg/dm3
5º Engler
10 bar
1 bar
325 l
Minimum motive pressure
Pump discharge per cycle DN100 x DN100
APLICATION LIM ITS POP-S DN100
Minimum density
Maximum viscosity
Maximum motive pressure
0,80 kg/dm3
5º Engler
10 bar
1 bar
21 l
APLICATION LIM ITS PPA-14
Minimum density
Maximum viscosity
Maximum motive pressure
Minimum motive pressure
Pump discharge per cycle DN80 x DN50
