1.8.3 Product assembly after cleaning
Re-assemble the main unit (3) with the shutter (2) and cosmetic cover (1) on the wall-mounting (4i).
Attention:
if different products are cleaned at the same time, re-mount every principal unit in the specific
compartment from which they had been removed in order to avoid communication problems between Master
unit and Slave unit.
Once the main unit has been re-installed on wall, turn on the product using the main switch. The reset of the
cleaning counter must be driven by remote control.
How to reset after filter cleaning operation is explained in the controller instruction manual.
1.9 Working instructions for correct operation
Figura 1.10
ON/OFF Main Switch (0/1).
In case of one unit, turn on the product through “0/1” switch and then set a function by remote to activate the
product accordingly. In case of more units, refer to paragraph “Master-Slave products configuration” and, once
this procedure is ended, turn ON the products through 0/1 switch and press a function by remote to activate the
device.
Attention:
by running the first time, the product performs the auto calibration of the hygrostat.
It is possible that during this step the products runs in “EXTRACTION” to bring the humidity of the environment at
the necessary level for the auto calibration.
1.10 Problems
If the product does not turn on, or in case of function problems such as strange noise, disconnect the product
by setting on “0”, the “0/1” main switch placed on product side. Contact immediately your retailer and ask for
assistance.
VALSIR S.p.A.
Località Merlaro, 2
25078 Vestone (BS) - Italy
Tel. +39 0365 877.011
Fax +39 0365 81.268
e-mail: [email protected]
www.valsir.it
Soggetta all’attività di direzione e coordinamento ex art. 2497 bis C.C.
da parte di Silmar Group S.p.A. - Codice Fiscale 02075160172
L02-872/0 - Marzo 2018 - P06157000
