3) Start Body Analysis
Stand straight and keep both feet flat on the strain gauge sensor. Wait until weight is shown
on display is stable and locked. The number will flast 3 times and then enter calculation state.
. When the Body fat analysis is flashing, you can then step off from the scale.
All measure Values will be shown twice alternately in 60 seconds (4 seconds intervals). The
scale will then switch off automatically.
3) Alarm Prompt
Low battery:
When battery is low, the display will show ‘LO’ symbol. Please install new
battery for accurate measures.
Over-load:
When the weight value exceeds the measured values, the display will show ‘O-Ld’.
Error:
When display show ‘ERR’, please take note of the following:
1) Not bare feet for indentifying body fat measurement.
2) Steping off the scale before body fat analysis procedure is complete.
3) Feet are not place on strain gauge sensor for body fat measurement.
4) The soles of your feet are not clean,
eg. Feet perspiration etc.
5) Exceed weight range.
mus
BONE
kg
SET
%
water
SET
KCAL
SET
%
SET
BMI
SET
kg
SET
SET