34
Owner’s Information
Pilot Flame can be seen between logs (1300IL) or left of the
fi
rst
rock (1300IR)
Pilot
Flame
Correct
Flame
Picture—
Logs
Correct
Flame
Picture—
Rocks
Thermocouple
Probe must be
in Flame
To re
fi
t the window:
1. Place it in its bottom railing and push its top against
the
fi
rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
3. Pull out the top of the window and release it to
insure the springs return it.
4. Apply light hand pressure against the window frame
sides to bed-in the window seal.
Soot or dust can be brushed from the ceramic logs
and
fi
rebox walls using a soft brush. Dust can also
be removed from the burner using a soft brush after
removing the ceramic logs. When cleaning, make sure
that no particles are brushed into the slots of the burner.
Checks
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Light
fi
xture without glass cover
100W Halogen Light Bulb (119mm)
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Light Bulb Replacement (if installed)
The appliance may be equipped with a
decorative light inside the
fi
rebox located
in front of the window. To replace the light
bulb, follow these steps:
1. Turn off the decorative light wall
switch.
2. Locate the light
fi
xture. Loosen the screws of
the glass cover retaining tabs.
3. While holding the glass cover so it does not fall
and shatter, swivel one or both of its retaining tabs
to free the glass. Gently remove the glass cover.
4. Remove the light bulb from its socket by pushing
towards one end.
5. With a gloved hand, replace with a new light bulb
using a 100 watts halogen 130 volts (type J T3,
119 mm long).
6. Test the bulb by turning the wall switch on. Turn
the switch off again to complete the operation.
NOTE: If the bulb is new and not functioning, turn
off the dimmer switch and call your local electrician
for inspection.
7. Put the glass cover back in place and, while
holding it, turn the retaining tab(s) to retain
the glass.
8. Tighten the tabs’ screws.
Light
fi
xture with glass cover
Tab
Tab
OWNER’S INFO
