![Valor Vega 200 Gas Скачать руководство пользователя страница 24](http://html1.mh-extra.com/html/valor/vega-200-gas/vega-200-gas_installer-and-owner-manual_3317023024.webp)
Lighting the burner.
Depress the control knob and rotate
it SLOWLY anticlockwise to the pilot
ignition position (See figure 2). A 'click'
will be heard as the integral piezo
operates. A flame should appear at the
pilot. The pilot can be seen by looking
through the gap in the fuel effect (See
figure 3). Keep the control knob
depressed and hold the pilot ignition
position for five seconds. When the
control knob is released the pilot flame
should remain lit. If a flame does not
appear at the pilot then turn the
control knob clockwise to the 'OFF'
position and repeat the above.
Operating the burner.
When the pilot burner is operating
properly, gradually turn the control
knob anti-clockwise to 'HIGH'
position. (Depress the knob slightly to
get past the pilot ignition position).
The main burner should now light.
Depress the control knob slightly to
release from the 'HIGH' position and
turn back (clockwise) to 'LOW'. While turning, the burner flames should gradually
become lower but remain alight. Depress the control knob slightly to release from the
'LOW' position and turn back (clockwise) to the Pilot ignition position. The main
burner should extinguish but the pilot should remain alight. Depress the control knob
slightly and turn back (clockwise) to turn OFF. This will extinguish the pilot.
While cooling, the ceramic fuel effects may make some crackling noises. This is quite
normal.
Note i)
If the flames go out while setting the control, repeat the full lighting
procedure. If the flames repeatedly go out have the stove serviced.
ii)
Please note. When first turned on the flames will appear predominantly
blue. The fuel effect pieces will take time to warm up. Although some glow
will be seen after approximately ten minutes, the full visual effect will only
be apparent after a somewhat longer time.
iii)
The appliance will operate to its maximum potential if the flue is primed
during the first 20 – 30 minutes of operation. To do this, simply slide the
control button to its highest setting. This will also burn off any carbon
deposits that may have formed during previous operations.
Page 24
©
Baxi Heating U.K. Limited 2010.
OWNER GUIDE
Figure 3.
Figure 2.
Содержание Vega 200 Gas
Страница 19: ...Page 19 Baxi Heating U K Limited 2010 OWNER GUIDE OWNER GUIDE ...
Страница 27: ... Baxi Heating U K Limited 2010 ...
Страница 28: ... Baxi Heating U K Limited 2010 ...