7.
Place the remaining type “A” coal
between the front and rear base coals.
The letter “A” should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type “B” coal to its
right is appreciably larger than the
gap between it and the type “A” coal
to its left but do not have it touching the type “A” coal. This will give the best flame
effect. See figure 28.
13. FIREFRONT CASTING
8
INSTALLATION
1.
All models except black & chrome front casting:
Fit the fire front casting to the front surround. Locate
the two screw heads at the rear top corners of the
casting through the keyhole slots at the inner sides of
the surround. If the screw heads do not project
enough or project too far, the screws can be adjusted.
Lower the casting so that it rests on the hearth. See
figure 29.
Black & chrome front casting: Place the fire front
casting in front of the appliance.
2.
Place the bottom front cover casting in position
below the fire front casting.
14. FULL OPERATING CHECKS
8
14.1 Recheck the Control Settings
With the ceramic fuel effect in position the control operation must now be fully
rechecked. Make sure that the isolating valve at the ‘T’ connector is open.
!
When first turned on from cold, the flames will appear predominantly blue.
!
When operating the fire for the first time, some vapours may be given off which
could set off smoke alarms in the vicinity. These vapours are quite normal with new
appliances. They are totally harmless and will disappear after a few hours use
.
14.1.1 Lighting the burner
1.
If closed
,
open the isolating valve at the inlet ‘T’ connector.
2.
Depress the control knob and rotate it anticlockwise to the pilot ignition position. A
Page 26
INSTALLER GUIDE
Figure 28.
Figure 29. Firefront casting
location
