resistant material. If necessary
cut the closure plate but make
sure that it overlaps the fireplace
opening sufficiently to allow
satisfactory sealing. Make sure
that the rectangular air relief
opening is fully within the
fireplace opening.
5.4.2
Wall mounting
See figure 8.
The closure plate must be fitted
and sealed to the hearth and
fireplace opening using a
suitable heat resistant material. If
necessary cut the closure plate
but make sure that it overlaps the
fireplace opening sufficiently to
allow satisfactory sealing. Make
sure that the rectangular air relief opening is fully within the fireplace opening.
The bottom of the appliance must be at least 50mm above any carpet or other floor
covering. To achieve this, the bottom of the flue spigot opening must be at least 495mm
above the finished floor covering.
5.4.3
Check the flue pull with closure
plate fitted by applying a lighted match
or smoke match to the flue spigot
opening in the closure plate and observe
the smoke. If there is a definite flow
continue with the installation. If not
check the fitting of the closure plate. The
fireplace flue pull check described in
section 5.2 should have confirmed that
the fireplace itself is satisfactory.
Page 14
INSTALLER GUIDE
Figure 8. Closure plate for Wall Mounting.
Figure 9. Wall fixing holes