2
Casting Tolerances
Due to the nature of cast iron, dimensional consistency
may vary from one unit to the next and some variation
in surface fi nish and fl atness is to be expected. We
have done our best to control and make allowance for
this; however some variation is inevitable.
Wall & Floor Fixing
The President FS can be installed against a wall or in
the room away from walls. The appliance is designed
to be fi xed to the fl oor. The appliance can additionally
or alternatively be fi xed to a rear wall. The fi xing
positions are shown in fi gure below. The appliance is
approved for installation directly on wood fl ooring. If the
appliance is installed directly on carpeting, vinyl tile or
other combustible material other than wood fl ooring, it
must be installed on a metal or wood panel extending
the full width and depth of the appliance.
Front & Sides Pack
(Box 1)
1 Front Casting unit with
Barrier Screen
2 Side Casting units
1 Top Baffl e
2 Stand-off Spacers
1 Pack of Screws & Washers
Top Pack (Box 2)
1 Top Casting
1 Top Infi ll Plate
Kit Contents
Top Baffle
Stand-offs
Spacers (2)
Infill Plate
Top
Casting
Front Casting with
Barrier Screen
Side Casting
Floor Requirements
The 530 heater is approved for installation directly
on any combustible material other than soft fl ooring
material such as carpet or vinyl.
Mantel Requirements
The President FS may be installed with a combustible
mantel provided clearances are maintained as
indicated in the Dimensions and Clearances. Be
aware that although safe, some combustible materials
and fi nishes at the listed clearances may, over time,
discolor, warp, or show cracks. Care should be taken
when choosing materials—consult your fi replace
dealer.
