7
Owner’s Information
Thermocouple
probe must be
in flame
Correct
fl
ame appearance
With Logs
With Coals
With Rocks
4. Pull the top of the window forward
and release to ensure the springs
return it in position.
5. Similarly check the bottom of the
window by pulling it forward and
releasing.
6. Apply
fi
rm hand pressure around
the window frame to ensure the
window is sealed tight against the
fi
rebox.
7.
If the Hot Glass Warning plate has been removed
from the front lower corner of the window,
reinstall it by sliding it between the glass and
the frame as indicated.
8.
Reinstall the front and barrier screen.
Checking Pilot and Burner Flames
A periodic check of the pilot and burner
fl
ames should
be made. Check after the
fi
re has been on for at least
30 minutes. The pilot
fl
ame must cover the tip of the
thermocouple probe. The main burner
fl
ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl
ammable vapors and liquids. Inspect the vent terminal
outdoors regularly to make sure that dirt, snow, insects,
leaves, shrubs, trees do not obstruct it. Examine the
whole vent system regularly. We recommend annually.
Using Handset Wall Holder
Your
fi
replace equipment includes a wall
holder to store the handset. If it hasn’t be
installed, refer to the instructions further
on in this manual for the installation.
Safety warning plate
WARNING
F O R S A F E T Y P U R P O S E , ensure the
barrier screen is re-installed on the
fi
replace
front after maintenance.
!
WARNING
Failure to install the window correctly can
leak carbon monoxide, affect the performance
of the
fi
replace, damage components, cause
overheating resulting in dangerous conditions.
Damage caused by incorrect window installa-
tion is not covered by the Valor warranty.
!
DANGER
The window unit must be correctly installed,
fastened and sealed after servicing or serious
bodily injury and/or damage to the appliance
may result.
To ensure a safe operation:
•
Double-check that the bottom of the window
frame is correctly bolted at the bottom;
•
Verify that the levers are hooked properly to
the window tabs then;
•
Pull out the top and bottom of the window and
release it to insure the springs return it;
•
Ensure the window is sealed before operation.
!
OWNER’S
INFORMATION
