18
Installation
Window & Optional Fan
Remove Window
It is easier to remove the window and all the items
packed inside of the
fi
rebox to make the engine lighter
for installation.
1. Release the spring bolts at top and bottom of the
window by pushing and turning 1/4 turn.
2. Lift the window and set it aside in a safe place to
avoid damage.
Unpack Stove Casing
1. Rough-in the gas line and electrical wiring for a fan
if any.
2. Decide where the stove should be positioned to
avoid moving it once all the casing is put together.
3. Unpack the casing and follow the instructions
supplied with each model (MFCS01, MFCS02 or
MFCS05).
Reposition Lighting Instructions Plate
Roll the lighting instructions cards and tucked in at the
rear above the angled
fl
ange or fan (if installed).
x 4
Unclip Remote Control Receiver
Under the
appliance, the
receiver box is
clipped to the
burner pipes to
facilitate
transportation.
Unclip the box
and let it hang
while you
fi
t the
gas pipe.
Install Optional Fan (if required)
If this installation requires the optional fan, it is easier
to install it at this point.
1. Remove the mounting plate from the fan and dis-
card it.
2. Install the fan motor at the back of the heater. Using
the lower set of
fi
xing holes on the fan will ensure
more space to handle the receiver in front of the
fi
replace.
See 555CFK—Circulating
Fan Kit manual for complete
fan installation details.
Receiver hooked to burner pipes
Unscrew 3 screws and
remove fan mounting
plate
Lower set of
fi
xing holes
Rear view
