32
Snap connector
Cable tie
Side slot
Rear view
Front view
7. Align the molex connection on the switch cable of
the harness assembly and connect to switch.
8. Mount the switch plate to the junction box with
2 screws provided. Note: Place the switch left or
right to suit the homeowner wishes.
9. Locate and secure the magnet plates using 2 ‘long’
screws provided.
10. Place and secure the
cover plate to the box us-
ing 4 screws provided.
11. Feed the cable tie through the 2 side slots of the
battery cover assembly.
12. Position the battery holder to the rear face and
secure together with a cable tie. Note that clear-
ance is required for battery snap connection.
13. Make the snap connec-
tion, load 4 AA alkaline
batteries into the holder
(included with
fi
replace)
then feed back into the
junction box assembly.
Note: Do not put batter-
ies in the receiver, only in
the battery holder by the
wall switch.
14. Test the operation of the wall switch—see Appendix.
Installation
Remote Battery & Wall Switch Kit
